VG Abstract
By Sherilyn Williams-Stroud
Microseismicity induced by hydraulic fracture stimulation of a horizontal well was mapped with a near-surface buried array. Distinct linear trends of events were not parallel to the direction of fast shear wave polarization measured in the reservoir with a crossed-dipole anisotropy tool. Analysis of core from a nearby well revealed numerous calcite-filled fractures that did not induce shear wave polarization, but did significantly impact the failure behavior of the reservoir rock during the stimulation treatment. Hydraulic fracture simulation with DFN modeling and source mechanism analysis supports the interpretation of reactivated existing fractures rather than the formation of hydraulically-induced tensile fractures.
Request a visit from Sherilyn Williams-Stroud!
American Association of Petroleum Geologists (AAPG)
Added on 16 November, 2016
VG Abstract
By David Weinberg
This is a less-technical education topic. It can be condensed to an hour or given as 2 two-hour sessions. It stresses selected controversial aspects of fracking that touch some combination of environment and economics and includes a short video of how fracking is done.
Request a visit from David Weinberg!
American Association of Petroleum Geologists (AAPG)
Added on 19 March, 2015
VG Abstract
By Sherilyn Williams-Stroud
Hydraulic fracturing has been around for decades. This talk describes some of the first applications of the technology, how it developed over time, and our current understanding of its impacts with some discussion of both water and earthquake hazards.
Request a visit from Sherilyn Williams-Stroud!
American Association of Petroleum Geologists (AAPG)
Added on 16 November, 2016
VG Abstract
By Sherilyn Williams-Stroud
Analysis of microseismicity induced by hydraulic fracture stimulation in the Marcellus Shale shows changes in stress state for different zones of failure. During the treatment, shear failure occurs on both the J1 and J2 fracture orientations in response to different maximum stress orientations, indicating localized changes in the orientation during the treatment. Reactivation of a fault near the wellbore is associated with failure mechanisms with a higher volumetric component, indicating possible inflation of faults and fractures by the introduction of the slurry. Quantification of the stress conditions that are associated with inflation could potentially be used to optimize the stimulation by identifying which fractures will preferentially take on slurry volume.
Request a visit from Sherilyn Williams-Stroud!
American Association of Petroleum Geologists (AAPG)
Added on 16 November, 2016